The zero-gas consumption blast heat control system uses S7200PLC + 7-inch color touch screen display automatic control, adopts the international standard MODBUS communication protocol, all sensors are connected to the bus, which is more reliable and simpler than distributed connection; Chinese interface; vivid color screen, can be connected to the PC through the RS485 interface for parameter setting and data acquisition and monitoring.
Technical indicators
(1) Temperature measurement: 00 ~ + 300 ℃, ± 1 ℃ accuracy
(2) Power input: AC voltage 220v ± 10%.
(3) Power consumption: 10W.
(4) Switch input: 14 points, dry contact input.
(5) Switch output: 26 points relay contact, 220V/2A, normally open contact.
(6) Analog: 10 inputs (4-20ma=6400-32000)
(7) Working environment: temperature 0 ~ 50 ℃, humidity not more than 85%, vibration not more than 0.5g.
There is no obvious dust, acid, corrosive gas, or substance in the surrounding air.
(8) Communication: RS485 interface, half-duplex mode, MODBUS-RTU communication protocol, effective distance ≤ 1200m.
You may like:
Do I Need A Filter For My Air Compressor
Do I Need A Filter On My Air Compressor
How Far Should Filter Be From Air Compressor
How To Change Air Filter On Lg Linear Compressor Refrigerator
How To Clean Air Compressor Filter
How To Clean Compressor Air Filter
How To Install Air Compressor Filter
How To Install Air Filter On Air Compressor
How To Install Water Filter On Air Compressor
Where To Install Air Compressor Filter
Inquiry
Product Description
|
Working conditions and technical indicators |
|
|
Purge Air |
≤0% |
|
Inlet pressure |
0.6~1.0Mpa |
|
Inlet oil content |
≤0.1mg/m³ |
|
Dew point |
-20℃~-40℃ |
|
Standard working period |
8 hours |
|
Inlet temperature |
0℃~45℃ |
|
Power |
380V/50HZ |
Construction Cases
Contact Us for More Details
Don't hesitate to contact when you need us!







Conclusion up front: If you compress air, you need an oil-water separator. If you have one, you need to maintain it. A well-maintained separator protects your ...
View MoreWalk through any plant that runs pneumatic tools, laser cutters, or precision control valves, and you will eventually hear the same complaint: the air line is ...
View MoreAt a petrochemical plant, a sticking control valve, a drifting analyzer, or a slow-acting emergency shutdown valve usually has one root cause: contaminated or ...
View MoreChemical process cooling equipment is not just about making process fluids cold. It is about controlling temperature precisely enough to protect reactors, stab...
View More